施工機具安全防護措施
6.5. Safety procedures of construction machines
現場所有機械設備必須按照施工平面布置圖進行布置和停放，機械設備的設置和使用必須嚴格遵守施工現場機械設備安全管理規定，現場機械有明顯的安全標志和安全技術操作指示牌，具體要做到：
All mechanical equipment on site shall comply with the layout plan for arrangement and parking. The setting and application of the mechanical equipments shall strictly observe the safety regulation of management of mechanical equipment on construction site; the machinery on site shall have obvious safety sign and safety operation sign; the detail information as follows:
拉伸鋼筋時周圍要設防護欄桿，后側面設防護擋板；
Set up the guarding rail while drawing the reinforcing bar; the back side shall set the protecting board for guarding;
攪拌機應搭設防砸、防雨操作棚；
The mixer shall equip with the construction shed for protection of falling objects and rain-proofing;
所有機械設備應經常清潔、潤滑、緊固、調整、不超負荷和帶病工作；
All mechanical equipment shall be cleaned, lubricated, fastened and adjusted constantly. The overload and operating with the hidden safety trouble is not allowed;
機械在停用、停電時必須切斷電源；
Machinery must cut off the power while out of service or in a power failure;
對新技術、新材料、新工藝、新設備的使用，在制定操作規程的同時，必須制定安全操作規程；
It is necessary to establish the safety operational procedure as well as operational procedure for the application of the new technology, new material, new process and new equipment
對特殊工序，必須編制作業方案，提出確保安全措施。
As to the special procedure, it is necessary to work out construction scheme and the safety measure as well.
6.6. 施工用電安全措施
6.6. Safety measure of power consumption for construction
施工現場用電線路的設置和架設必須按江蘇省有關規定與用電布置圖（見附圖）進行設置和架設。電纜線均應架空，穿越道路除防護套管外，埋置深度應超過0.2米，全部采用三相五線制。
The arrangement and erection of power consumption for construction site shall observe the relevant regulations and layout drawing for power consumption of Jiangsu Province (see figures). The cable thread shall be overhead installed and pass through external side of road protecting sleeve pipe. The embedded depth shall exceed 0.2 meters and all adopt the three phase five wire system.
現場配電房醒目處掛有警示標志，配備一組有效的1121干粉滅火器，配電房鑰匙由現場電工班派專人保管。
Warning marks shall be arranged in the striking place of on site distribution substation, which equipped with a group of effective 1121 dry powder extinguishers. The key of distribution substation shall be specially assigned for keeping arranged by the on site electrical shift.
現場配電箱設有可靠有效的三相漏電保護器和觸電保護器，動作靈敏、動力、照明分開，與配電房內的漏電保護器形成二級保護，使施工用電人身更安全。
The on-the-spot distribution box equips with reliable and effective three phases protecting device for electricity leakage and electrical shock protective device, which have a sensitive movement; separated motive force and illumination; and a secondary protection formed by the leakage protector inside the distribution room, so as to ensure the personnel security of power consumption for construction.
現場所配電箱應統一編號、上鎖、專人保管，箱殼接地良好。施工用電的設備、電纜線、導線、漏電保護器等應有產品質量合格證。漏電保護器要經常檢查，發現問題立即調換，熔絲要相匹配。
Distribution box on site shall have a unified numbers, locking, and personnel specially assigned for custody; the grounding of the unit housing shall maintain in a good a condition. The products quality certificate shall be available for construction equipments of power consumption, cable line, wire, and leakage protector, etc. Check the leakage protector and displace in case of abnormal condition; the fuse wire of leakage protector shall be matched.
使用安全色和安全標志。
Apply the safety color and safety marking.
6.7. 卸料平臺安全保證措施
6.7. Safety Assurance Measure for Unloading Platform
制作時應嚴格按照方案規定的尺寸及焊接要求施工，所有接縫均要求滿焊，焊縫高度不小于6mm
Strictly observe the size and the requirements of welding regulated in the scheme; full weld is required in all seams; the height of welding seam shall not smaller than 6mm
所選材料均應有材質證明，不合格產品堅決不予使用。
Material quality certificate shall be available for the selected materials; the application of the subquality product is not allowed.
平臺腳手板及擋腳板均應與主框架及欄桿用雙股8號鐵絲綁扎牢固。安全網應連續與欄桿綁扎牢固。
Platform scaffold board and footplate guard shall be fixed with main frame and double 8 iron wires with main frame and railing. The safety net shall be firmly fixed with the railing in succession.
卸料平臺使用應成立一個專門小組，由塔司、信號工、架子工組成，使用前進行專門的安全交底，進行安裝和提升時信號工與塔司應密切配合。
The application of unloading material platform shall establish a special group, which comprised by tower department, signalman, and timberman. Before application it is necessary to perform special exchange procedure for security information; the signal worker and tower department shall cooperate closely in case of installation and hoisting procedure.
吊裝、拆除大平臺應由專業人員進行，鋼絲繩固定螺絲未連接可靠不得落鉤，同時未完全拆除不得起吊。
Hoisting and removing operation of large platform shall be performed by professional personnel; hook shall not set down while the screw of steel wire rope is not fixed; and the hoisting operation shall not be permitted in case of removing operation are not completed.
大平臺第一次使用前應進行堆載試驗，合格后方可使用。
Pile-loading test is required in case of first application of large platform and engage in application after being qualified.
大平臺安裝時應保證端部略上抬不超過100-200mm。
In case of large platform installation, it is necessary to ensure the end part shall not exceeds 100-200mm in upward direction.
2023年8月15日